Grizzly G9742 Manuale Utente Scaricare il pdf (Pagina 28)

-26-

G9742 Metal Cutting Bandsaw (Mfg. Since 11/06

Always disconnect power

to the machine before

performing maintenance.

Failure to do this may

result in serious person-

al injury.

Lubrication

Cleaning the Model G9742 is relatively easy.

Keeping metal chips away from bandsaw mecha-

nisms is important to making sure that your

bandsaw lasts a long time. Use a shop vacuum

or brush off metal chips frequently.

Cleaning

SECTION 6: MAINTENANCE

Schedule

D

C

E

For optimum performance from your machine,

follow this maintenance schedule and refer to any

specific instructions given in this section.

Daily Check

• Loose mounting bolts.

• Damaged saw blade.

• Worn or damaged wires.

• Any other unsafe condition.

• Clean after each use.

• Proper blade tension.

Monthly Check

• Lubricate vise screw.

• Check V-Belt for wear.

Annual Check

• Inspect gear lubrication.

The gearbox and all bearings are sealed and per-

manently lubricated so no scheduled lubrication is

needed. However, you must periodically lubricate

adjustment locations and bare metal surfaces.

Refer to Figure 36 for lubrication points.

Lubricate the following areas listed below:

A. Blade Tension Mechanism: Open the main

blade guard, and drop a few drops of oil on

the tension knob lead screw.

B. Blade and Guides: Drop a few drops of

light machine oil on the blade and the blade

guides daily.

C. Gear Box: Is packed with grease and should

only be changed if you suspect contamina-

tion has entered.

D. Table and Machined Surfaces: Keep bare

metal surfaces rust-free with regular applica-

tions of products like SLIPIT®. For long term

storage you may want to consider products

like Boeshield T-9™.

E. Vise Lead Screw: Drop a few drops of light

machine oil on the vise lead screw weekly.

Figure 36. Lubrication points.

B

A

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Commenti su questo manuale

Nessun commento