Grizzly G9742 Manuale Utente Scaricare il pdf (Pagina 17)

G9742 Metal Cutting Bandsaw (Mfg. Since 11/06

-15-

Shipping Strap &

Stop Adjustment

To ensure that your bandsaw arrives without

damage to the hinge system, a shipping strap

was installed. After removing the shipping strap,

you will have to make a series of adjustments,

beginning with the feed stop bolt.

To remove the shipping strap and adjust the

feed stop bolt:

1. Remove the shipping strap hex bolt and

strap with a 12mm wrench (see Figure 11).

Note: Keep this shipping strap in the event that

you must transport or ship the bandsaw.

2. Adjust the feed stop bolt and jam nut with a

14mm wrench (Figure 12), so the bandsaw

blade teeth are just below the table surface

when the cut is complete.

Figure 11. Removing shipping strap.

Figure 12. Feed stop bolt.

Squaring Vise to

Blade

To ensure that your bandsaw will make cuts that

match the degree scale, you must make sure to

square the vise to the blade.

To square the vise to the blade:

1. Rotate the headstock until the pointer reads

"0" on the tabletop scale, and tighten the

headstock lock lever so the headstock stays

indexed at zero.

2. Using a 6mm wrench, loosen the two cap

screws that hold the vise to the table (see

Figure 13).

Figure 13. Squaring vise to blade, headstock,

and table scale.

Headstock

Lock Lever

3. Using a small machinists square, adjust the

vise so it is square to the blade.

4. Tighten the two cap screws, so the vise and

blade are square with one another.

Square

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Commenti su questo manuale

Nessun commento