Grizzly G0516 Manuale Utente Scaricare il pdf (Pagina 25)

G0516 Lathe/Mill -23-

Adjusting

Compound Slide

Similar to the cross slide, the compound slide fea-

tures a scale that displays graduations of one

thousandths of an inch (.001"). Unlike the cross

slide, the compound slide can be rotated to a set

angle and then it can be moved back and forth

along the axis of that angle.

To adjust the compound slide:

1. Loosen the compound slide bolts shown in

Figure 24 to allow it to be rotated.

Figure 24. Compound slide bolts.

Figure 23. Adjusting handwheel scale.

2. Rotate the compound slide to the angle

needed for your procedure.

3. Tighten the compound slide bolts, and check

the angle again to make sure it did not move

during tightening.

4. Use the compound slide handwheel to move

the tool back and forth along the axis of the

new angle. Similar to adjusting the cross

slide handwheel, make sure the threads are

engaging and all backlash has been cleared

before you set the handwheel scale to “0”, or

it will not be accurate.

Adjusting

Cross Slide

The cross slide is only designed to move perpen-

dicular to the longitudinal axis of the lathe, and it

features a scale on the handwheel that displays

graduations of one thousandths of an inch

(.001").

To adjust the cross slide:

1. Using the handwheel, back the cross slide

away from your starting point by at least

.015", then move the cross slide forward to

your starting point. Note—this procedure will

clear any free movement (or backlash) in the

lead screw so your handwheel scale reading

will be accurate.

2. Hold the handwheel still and turn the scale

so the “0” mark lines up with the “.000” mark

on the cross slide, as shown in Figure 23. As

long as you avoid backlash by continuing to

move the cross slide in the same direction,

the scale on the handwheel will be accurate.

3. After moving the cross slide backward after

your operation, remember to clear the back-

lash before moving the cross slide forward to

the “0” mark for the next cut.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 71 72

Commenti su questo manuale

Nessun commento

Grizzly G0516 Manuale Utente Pagina 25

Commenti su questo manuale

Prodotti e manuali riguardandi Attrezzi Grizzly G0516