Grizzly G0516 Manuale Utente Scaricare il pdf (Pagina 22)

-20-

G0516 Lathe/Mill

Installing Chuck

or Faceplate

Figure 17. Tailstock components.

Installing Tailstock

Dead Center

There are 2 dead centers included with the Model

G0516. The smaller dead center is a MT#2

(Morse Taper) and fits in the tailstock barrel.

To install the tailstock dead center:

1. Familiarize yourself with the tailstock compo-

nents shown in Figure 17.

2. Make sure that the MT#2 dead center and

tailstock barrel are clean and free of any dirt,

dust, grease or oil. These parts will last

longer and remain accurate when properly

cleaned before each assembly. Morse tapers

will not interlock when dirt or oil are present

on the mounting surfaces.

To install a chuck/faceplate:

1. Disconnect the lathe/mill from the power

source!

2. Insert the 3 mounting studs into the back of

the chuck and tighten them down. If you are

switching chucks, take the mounting studs

out of the previously removed chuck and use

them in the chuck you are going to install.

Also, make sure that a chuck mounting nut is

on each of the studs.

3. Make sure that the knurled lock plate is rotat-

ed all the way toward the front of the lathe.

4. Insert the chuck into the spindle nose.

5. Rotate the knurled lock plate toward the back

of the lathe until it stops. If the lock plate will

NOT rotate more than a fraction of an inch,

then the chuck is not completely inserted.

Make sure the chuck is completely inserted

so the lock plate can be rotated properly.

6. Hold the chuck/faceplate with your hand or a

key. Using a 17mm wrench, snug the 3

chuck mounting nuts to the back of the

knurled lock plate, then final tighten all 3 with

even pressure.

7. Remove all wrenches and chuck keys from

the chuck/spindle nose.

8. Move the lathe eyeshield down over the

chuck before operating.

Dead Center

Barrel Barrel Lock

Barrel

Handwheel

Barrel

Handwheel Scale

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 71 72

Commenti su questo manuale

Nessun commento

Grizzly G0516 Manuale Utente Pagina 22

Commenti su questo manuale

Prodotti e manuali riguardandi Attrezzi Grizzly G0516